Boom XB-1

Type of aircraft
XB-1 ("Baby Boom")
Boom technology XB-1 baby boom.jpg
Early design of the XB-1 demonstrator
Role Supersonic technology demonstrator aircraft
National origin United States
Manufacturer Boom Technology
First flight 22 March 2024[1]
Status In flight testing as of March 2024
Number built 1

The Boom XB-1 "Baby Boom" is a one-third-scale trijet supersonic demonstrator designed by Boom Technology (dba "Boom Supersonic"[2]) as part of development of the Boom Overture supersonic transport airliner. Powered by three General Electric J85s, it is planned to maintain Mach 2.2, with over 1,000 nautical miles (1,900 km; 1,200 mi) of range. The XB-1 began taxi tests began in December 2022,[3] and conducted its maiden flight on 22 March 2024.[1]

Development

The design was unveiled in Denver on November 15, 2016,[4] and it was initially intended to make its first subsonic flight in late 2017, powered by three General Electric CJ610 turbojets (a civilian J85), with subsequent supersonic flight testing at Edwards Air Force Base.[5]

By April 2017, enough financing was secured to build and fly it.[6] Its preliminary design review was completed by June 2017, with a switch of engine to the military version of the J85 to take advantage of its extra thrust. It was then anticipated that flight tests would start late 2018.[7] In 2017, the composite wing spar was load tested while being heated in a hydraulic testbed at 300 °F (149 °C), above the heat soak operational temperature. First expected supersonic flight slipped to 2019.[8]

By July 2018, the aerodynamic design was completed, the horizontal tail assembled, and the engines received. The Spaceship Co., manufacturer of Virgin Galactic’s vehicles, was announced as a partner for flight tests in Mojave, California.[9] Flight tests were delayed again for 2019 due to challenging aerodynamics and further engine change; from the 3,500 pounds-force (16,000 N) J85-21 to the 4,300 lbf (19 kN) J85-15.[9]

The XB-1 design went through three sets of wind-tunnel tests. The first indicated that predicted calibration was off by 30%. The second set of tests confirmed accurate calibration, and a third set of tests confirmed design safety. Tunnel testing finished in November 2018, including takeoff and landing with gear doors' impact on stability as well as supersonic inlet testing. These tests had taken a decade on Concorde. The carbon-fiber layup of the fuselage halves was to begin in early 2019 for final assembly of the forward fuselage at the beginning of Spring. With total investment rising to $200 million, Boom was funded for XB-1 flight-testing to the end of 2020.[10] At the June 2019 Paris Air Show, Blake Scholl announced the date for first flight was pushed out to 2020, six months later than previously planned after including a stability augmentation system for better safety at high speed and at take-off and landing.[11]

In February 2020, with the completion of Boom's second simulator, tests began on XB-1 flight controls and system integration.[12] Static wing loading tests were carried out in March 2020, and the wings were mated to the fuselage in April[13] with the aft fuselage nearing completion in May.[14][better source needed] Engines and landing gear were installed later in August and September 2020.[15]

Testing

On October 7, 2020, Boom rolled out the XB-1 in a promotional, with an announcement that the maiden flight was expected in 2021.[16] In early 2021, it was expected to be flight tested around September 2022.[17] On July 26, 2021, Boom began testing and evaluating a forward-looking vision system (FLVS) as part of preparations for flight tests of the XB-1.[18]

In January 2022, Boom began conducting engine run-ups using the XB-1, in preparation for taxi tests and the first flight later in 2022.[19] In May 2022, ground testing was completed with engine run up done on all three engines. Undercarriage and flight systems were tested and deemed ready. Taxi runs and actual flight runs were expected in late 2022.[20] Further delays as of February 2023 pushed the expected first flight to mid-2023.[21]

In August 2023, the aircraft received its experimental certification of airworthiness from the FAA.[22] Medium-speed taxi testing was performed in November 2023, with the aircraft reaching a top speed of 94 knots.[23] Following testing, in January 2024 Boom delayed the first test flight to early 2024 to implement safety improvements. The three improvements identified were upgrading the landing gear for increased reliability, optimizing engine intakes for improved resistance to engine stall, and adjusting the aircraft's dampers for improved stability and control.[24][25]

The XB-1 took its first flight on 22 March 2024, flown by Chief Test Pilot Bill "Doc" Shoemaker from Mojave Air and Space Port.[1]

Design

A non-flying mockup of the XB-1 at Wings Over the Rockies Air and Space Museum

The XB-1 Baby Boom is 68 feet (21 m) long, has a 17 ft (5.2 m) wingspan and a 13,500-pound (6,100 kg) maximum take-off weight. Powered by three non-after-burning (“dry”) J85-15 engines with variable geometry inlets and exhaust, the prototype should be able to sustain Mach 2.2 with more than 1,000 nmi (1,900 km; 1,200 mi) of range.[4] As a technology demonstrator for the Boom Overture, the XB-1's trijet configuration matched that of the Overture. In 2022, the Overture was redesigned to a quadjet configuration.[26] The XB-1 retains the original trijet configuration.

It has a planned two-crew cockpit, with only one seat being fully developed in the demonstrator, and features a chined fore-body and swept trailing edges.[4] For thermal control, the environmental control system uses the fuel as a heat sink to absorb cabin heat.[8] The space for a second seat is taken up by testing equipment.[27]

Materials

The XB-1 is constructed of lightweight composites, titanium and A286.[27] Materials for the hot leading edges and 307 °F (153 °C) nose, and epoxy materials for cooler parts, are provided by Dutch TenCate Advanced Composites, high-temperature materials supplier for the SpaceX Falcon 9.[8] The airframe will be primarily intermediate-modulus carbon fiber/epoxy, with high-modulus fibers for the wing spar caps and bismaleimide pre-preg for the high-temperature leading edges and ribs.[8] The rear section of fuselage containing the engines is made from 90% titanium and 10% A286 stainless steel alloys.[27]

Specifications (preliminary)

Data from Aviation Week[4][needs update]

General characteristics

  • Crew: 1 (Design allows for a second seat)
  • Length: 68 ft (21 m)
  • Wingspan: 17 ft (5.2 m)
  • Height: 17 ft 0 in (5.2 m)
  • Max takeoff weight: 13,500 lb (6,123 kg)
  • Powerplant: 3 × General Electric J85-15[9] turbojet, 4,300[9] lbf (19 kN) thrust each

Performance

  • Maximum speed: Mach 2.2
  • Range: 1,000 nmi (1,200 mi, 1,900 km)

See also

Related development

References

  1. 1.0 1.1 1.2 "Boom Announces Successful Flight of XB-1 Demonstrator Aircraft". Boom Supersonic. Boom Technology. 22 March 2024. Retrieved 22 March 2024.
  2. "Boom Supersonic to Roll Out Historic XB-1 Demonstrator Oct. 7" (Press release). Boom Supersonic. Jul 8, 2020.
  3. "What is Taxi Testing?" (Press release). Boom Supersonic. Dec 13, 2022.
  4. 4.0 4.1 4.2 4.3 Guy Norris (15 November 2016). "'Baby Boom' Supersonic Demonstrator Unveiled". Aviation Week.
  5. "Potential Mach 2.2 Airliner Market Pegged At $260 Billion". Aviation Week. October 12, 2016.
  6. Aaron Karp (May 3, 2017). "Boom CEO sees market for 1,000 supersonic passenger jets by 2035". Air Transport World. Aviation Week.
  7. Guy Norris (Jun 18, 2017). "'Baby Boom' Demonstrator Passes Design Review". ShowNews. Aviation Week Network.
  8. 8.0 8.1 8.2 8.3 Guy Norris (Dec 5, 2017). "JAL Options Up to 20 Boom Supersonic Airliners". Aviation Week & Space Technology.
  9. 9.0 9.1 9.2 9.3 Guy Norris (Jul 10, 2018). "Boom Focuses On Derivative Engines For Supersonic Airliner Plan". Aviation Week & Space Technology.
  10. Graham Warwick (Jan 23, 2019). "Boom Advances Overture Supersonic Airliner As Demonstrator Takes Shape". Aviation Week & Space Technology.
  11. Greg Waldron (19 June 2019). "Boom XB-1 schedule slips, while JAL eyes Overture". flightglobal.
  12. "Boom's latest flight simulator advances flight test program for supersonic demonstrator" (Press release). Boom Supersonic. April 7, 2020.
  13. Hemmerdinger, Jon (May 14, 2020). "Boom mates supersonic XB-1's wings with fuselage". Flight Global.
  14. "Boom Technology's Supersonic jet with 1,700mph top speed ready for test flight". Zee News. 2020-07-13.
  15. "Boom - XB-1 Timeline". BOOM Supersonic. Retrieved 2022-07-20.
  16. Jon Hemmerdinger (7 October 2020). "Boom rolls out XB-1 supersonic demonstrator, lays out Overture timeline". FlightGlobal.
  17. Hemmerdinger, Jon (27 April 2021). "First flight of Boom's XB-1 demonstrator could happen next year: CEO". Flight Global.
  18. "Boom Tests Vision System For XB-1 Supersonic Demonstrator". Aviation Week. July 26, 2021.
  19. @boomaero (22 January 2022). "Plane spotters: Spied anything new on APA/KAPA's taxiways lately? Engine runs on our supersonic demonstrator are underway" (Tweet) – via Twitter.
  20. Bailey, Joanna (2022-05-11). "Supersonic Revival: Boom's XB-1 Is Already 80% Through Pre-Flight Testing". Simple Flying.
  21. Scholl, Blake (February 23, 2023). "How I Built This -Transcript" (Podcast). Event occurs at 29:06. Retrieved March 11, 2023. " We're going to take it down to the Mojave Desert for flight test probably around the middle of this year."
  22. "FAA Clears Boom Supersonic For XB-1 Flight Tests". Aviation Week. August 24, 2023. Retrieved 2024-02-27.
  23. "Boom - XB-1". Retrieved 2024-02-27.
  24. "Boom - XB-1". boomsupersonic.com.
  25. "Boom's Supersonic Demonstrator XB-1 Missed 2023 Flight Goal But Taxi Tests Planned". 4 January 2024. Retrieved 2024-02-27.
  26. "Refined Design: Boom Supersonic Unveils Latest Overture Renderings & Features". Jul 19, 2022. Retrieved 2024-03-06.
  27. 27.0 27.1 27.2 "From tip to tail: XB-1 nears full assembly". Boom Supersonic (Press release). Aug 25, 2020.

External links